I was planning to clad the outside of the timber section in tongue and grove board. This should give a quality finish, but I figured it would be easier to mount the tongue and grove onto sheets OSB.
I had a good amount if OSB to use anyway and it was a simple job to measure and cut some pieces.
We fixed the peices to the outside of the shed with screws.
Next I marked out a straight line down the length of the roof with a string line and cut down with the circular saw. Front and back. We screwed on a length of 2x2 timber and a length of roofing lat down each side. This would give a good edge for holding the rubber roof down.
No comments:
Post a Comment